In this work, a ceramic model has obtained from Iraqi bentonite as a base material with limited additions of alumina and silica. The selected material can bear temperatures higher than the bearing temperature of bentonite as it achieved tolerance temperatures (1300°C) based on X-ray diffraction patterns. It was found that the addition of alumina and silica led to the occurrence of basic phases such as mullite, quartz, cordierite and feldspar in percentages that depended on the percentage of addition in the mixture and the firing temperature, which was (1000-1300)°C.

In this paper, an ecological model with stage-structure in prey population, fear, anti-predator and harvesting are suggested. Lotka-Volterra and Holling type II functional responses have been assumed to describe the feeding processes . The local and global stability of steady points of this model are established. Finally, the global dynamics are studied numerically to investigate the influence of the parameters on the solutions of the system, especially the effect of fear and anti-predation.
In this work, yttrium oxide particles (powder) reinforced AL-Si matrix composites (Y2O3/Al-Si) and Chromium oxide particles reinforced AL-Si matrix composites (Cr2O3/AL-Si) were prepared by direct squeeze casting. The volume percentages of yttrium oxide used are (4, 8.1, 12.1, 16.1 vol %) and the volume percentages of the chromium oxide particles used are (3.1, 6.3, 9.4, 12.5 vol. %). The parameters affecting the preparation of Y2O3/Al-Si and Cr2O3/AL-Si composites by direct squeeze casting process were studied. The molten Al-Si alloy with yttrium oxide particles or with chromium oxide particles was stirred again using an electrical stirrer at speed 500 rpm and the molten alloy was poured into the squeeze die cavity. Th
... Show MoreThis study reports on natural convection heat transfer in a square enclosure of length (L=20 cm) with a saturated porous medium (solid glass beads) having same fluid (air) at lower horizontal layer and free air fill in the rest of the cavity's space. The experimental work has been performed under the effects of heating from bottom by constant heat flux q=150,300,450,600 W/m2 for four porous layers thickness Hp (2.5,5,7.5,1) cm and three heaters length δ(20,14,7) cm. The top enclosure wall was good insulated and the two side walls were symmetrically cooled at constant temperature. Four layers of porous media with small porosity, Rayleigh number range (60.354 - 241.41) and (Da) 3.025x10-8 has been investigated. The obtained data of temperatu
... Show MoreThe decoration structure in calligraphy painting is one of the variables that characterized the structure of the calligraphic composition due to the artistic, aesthetic and expressive properties of the letters of the Arabic calligraphy, which are represented by flexibility, compliance and the ability to form. Therefore, the researcher defined his problem by asking the following question: What is the decorative structure in the calligraphic painting? The study aimed to reveal the structure of the ornamentation in the calligraphy painting, while the researcher dealt with in the second chapter three sections, the first (the ornamental concept and meaning) and the second topic (the structural characteristics of the Arabic letter in the calli
... Show MoreA polycrystalline CdSe thin films doped with (5wt%) of Cu was fabricated using vacuum evaporation technique in the substrate temperature range(Ts=RT-250)oC on glass substrates of the thickness(0.8?m). The structure of these films are determined by X-ray diffraction (XRD). The X-ray diffraction studies shows that the structure is polycrystalline with hexagonal structure, and there are strong peaks at the direction (200) at (Ts=RT-150) oC, while at higher substrate temperature(Ts=150-250) oC the structure is single crystal. The optical properties as a function of Ts were studied. The absorption, transmission, and reflection has been studied, The optical energy gap (Eg)increases with increase of substrate temperature from (1.65
... Show MoreThe aim of the present study was to investigate the histological structure of the tongue in Mongoose (Herpestes javanicus) and its related to the feeding pattern. Five adult animals were used in this study . The tongues were dissected and fixed in 10% formalin, then prepared by following stages (dehydration, clearing, and embedding).The serial section(5µ) were stained with(H&E) and some special stains.The histological examination showed that the tongue consists of three tunicae (mucosa, submucosa and musclaris) and the lining epithelium of the filiform papillae is composed of keratinized stratified squamous epithelial tissue. The cylindrical papillae are covered with a highly keratinized stratified squamous epithelial tissue, whereas the k
... Show MoreThe histological structure of integument in Mastacembelus mastacembelus have been investigated from skin fragments cut from nine regions at body surface. The results revealed that the integument of the fish investigated comprises three principal layers- the epidermis, the dermis (corium) and the subcutis-All the three principal layers may further be divided into secondary layers according to the function performed by their cells. The epidermis may further divided into three layers- the outermost epithelial coverage, the middle layer and the basal layer (stratum germinatiuum)-The dermis consists of a relatively thin upper layer of loose vascular connective tissue called the stratum laxum and a thick lower compact layer- the stratum compactu
... Show More