Preferred Language
Articles
/
joe-361
Development the Mechanical Properties of (AL-Li-Cu) Alloy
...Show More Authors

The aim of this research is to develop mechanical properties of a new aluminium-lithium-copper alloy. This alloy prepared under control atmosphere by casting in a permanent metal mould. The microstructure was examined and mechanical properties were tested before and after heat treatment to study the influence of heat treatment on its mechanical properties including; modulus of elasticity, tensile strength, impact, and fatigue. The results showed that the modulus of elasticity of the prepared alloy is higher than standard alloy about 2%. While the alloy that heat treated for 6 h and cooled in water, then showed a higher ultimate tensile stress comparing with as-cast alloy. The homogenous heat treatment gives best fatigue behaviour comparing with as-cast and other heat treatment alloys. Also, the impact test illustrates that the homogeneous heat treatment alloy gives the highest value.

  

View Publication Preview PDF
Quick Preview PDF
Publication Date
Sun Jun 05 2016
Journal Name
Baghdad Science Journal
Preparation and Physico-Chemical Investigation Studies for the of Mn(II),Co(II),Ni(II) and Cu(II) Metal Complexes with Ligand 2- Hydroxybenzaldine Urea
...Show More Authors

Some of metal compounds have been synthesized of record ligand from aldehid interaction of a substance which is salicyladehyde with another material which is urea. During the analysis of the metal component, The prepared complexes were characterized by elemental analysis, IR ,UV-visible , conductivity and magnetic susceptibility measurements. this confirms the ratio[1:1] between the metal and ligand. It is found that theortical values agree with practical values All the studied complexes are suggested as an octahedral stereochemistry.

View Publication Preview PDF
Crossref
Publication Date
Sat Jun 29 2019
Journal Name
Journal Of The College Of Education For Women
The Repetition in Bushra Al Bustany Poetry: A Stylistic Study
...Show More Authors

يعد التكرار من الظواهر الاسلوبية التي اتخذت دورها في بناء النص الشعري الحديث ويقوم على جملة من الاختيارات الاسلوبية لمادة دون أخرى ولصياغة لغوية دون سواها ، مما  يكشف في النهاية عن سرّ ميل هذا النص الشعري أو ذاك لهذا النمط الاسلوبي دون غيره ، وعلى الرغم من ان التكرار يعد مسألة عامة وشائعة في العمل الأدبي ، فأن الاهتمام بهذا الجانب من المنهج الاسلوبي يأتي من جهة كونه مهيمناً له ايحاءاته ودلال

... Show More
View Publication Preview PDF
Publication Date
Wed Oct 05 2016
Journal Name
Al-academy
Numbers and Its Uses in the Al-Abbass Holy Shrine
...Show More Authors

The present research studies numbers and its uses in the Islamic ornament. The study consists of four chapters; the first is dedicated to the problem of the research, the value of the study, and the aim of the study, and its limit. The problem of the study deals with the uses of numbers in Islamic ornament and how these numbers were used for aesthetic purposes. What are the analytical bases that enable us to read the geometrical compositions ornament numerically? The value of the research is the study forms an analytical and visual study of the numbers in the Islamic ornamentation. Additionally, this study is an aesthetic assessment to the philosophy of the number and its uses in Islamic architecture. The study is limited to the ornament

... Show More
View Publication Preview PDF
Crossref
Publication Date
Tue Feb 05 2019
Journal Name
Journal Of The College Of Education For Women
The Conflict between Somalian – Ethiopian Aboyt Al – Oaghaden 1960 – 1978
...Show More Authors

The study of the subject shows us the couflict between Somalian- Ethiopian. About Al-Oaghaden (1960-1978). This province is purely Somalian area in their language ،manners ،
traditions ،and their most population from Migrant bedouin.
In the last nineteenth century ،Ethiopia had entered to exit from plateau ،and become nearly from Red Sea and Indian Ocean.
The study shows us ،the conflict between colonization countries ،about African horn ،then fore Ethiopia entered as partner to divide the zone area ، and that division hadn’t Cares about the unity of people ،or the similar of language or religoun ،for this reason which had interference happened between broders and division about the same tribe from more Century ،

... Show More
View Publication Preview PDF
Publication Date
Sat Jan 01 2011
Journal Name
Iraqi Journal Of Physics
The Effect of CdCl2 and annealing treatments on structural properties of CdS/CdTe heterojunction
...Show More Authors

CdS and CdTe thin films were thermally deposited onto glass substrate. The CdCl2 layer was deposited onto CdS surface. These followed by annealing for different duration times to modify the surface and interface of the junction. The diffraction patterns showed that the intensity of the peaks increased with the CdCl2/annealed treatment, and the grain sizes are increased after CdCl2/annealed treatment

View Publication Preview PDF
Publication Date
Wed Sep 01 2021
Journal Name
Iraqi Journal Of Physics
The Effect of Etching Time On Structural Properties of Porous Quaternary AlInGaN Thin Films
...Show More Authors

Using photo electrochemical etching technique (PEC), porous silicon (PS) layers were produced on n-type silicon (Si) wafers to generate porous silicon for n-type with an orientation of (111) The results of etching time were investigated at: (5,10,15 min). X-ray diffraction experiments revealed differences between the surface of the sample sheet and the synthesized porous silicon. The largest crystal size is (30 nm) and the lowest crystal size is (28.6 nm) The analysis of Atomic Force Microscopy (AFM) and Field Emission Scanning Electron Microscope (FESEM) were used to research the morphology of porous silicon layer. As etching time increased, AFM findings showed that root mean square (RMS) of roughness and po

... Show More
View Publication Preview PDF
Crossref (2)
Crossref
Publication Date
Tue Jun 30 2020
Journal Name
Iraqi Journal Of Market Research And Consumer Protection
FACTORY OF SORTING AND RECYCLING OF WASTE IN THE DISTRICT OF AL-MAHMOUDIYAH BETWEEN THE ECONOMIC AND ENVIRONMENTAL IMPACT: FACTORY OF SORTING AND RECYCLING OF WASTE IN THE DISTRICT OF AL-MAHMOUDIYAH BETWEEN THE ECONOMIC AND ENVIRONMENTAL IMPACT
...Show More Authors

The waste sorting and recycling plant in the district of al- Mahmudiya (Yusufiya) is the only laboratory in Baghdad governorate. It is the only one in Iraq that collects and recycles waste. After sorting, we have packages of raw materials (aluminum cans, glass bottles, plastic bottles, Nylon bags) as well as natural fertilizers (food residues and others) and a sanitary landfill with specifications that meet international standards; However, the absence of a structure for the management of the plant (manager, assistant manager, accountant, etc.) in addition to the non-supply of waste on a daily and continuous basis and the lack of cooperation of the Municipality of Baghdad with the management of the plant led to delay in the work

... Show More
View Publication Preview PDF
Publication Date
Wed Aug 01 2018
Journal Name
Journal Of Economics And Administrative Sciences
Prepare a plan for the Total Productive Maintenance in the light of the concurrent engineering A Field Study in AL-Askandria General Company Machanical Industries and AL-Musaib Electric Power Station
...Show More Authors

           Strives Total Productive Maintenance  to increase the overall effectiveness of the equipment through the early involvement in the design and manufacture of equipment productivity. It also operates in an environment of simultaneous engineering work on the synchronization of activities to take advantage of early information by maintenance engineers, design, operation, and that helps to reduce the faults and facilitate future maintenance tasks.

    Has adopted a search in the theoretical concept of the total maintenance productivity and concurrent engineering activities carried out during which the conjunction a

... Show More
View Publication Preview PDF
Crossref (1)
Crossref
Publication Date
Wed Feb 20 2019
Journal Name
Political Sciences Journal
Assessing the Impact of reformation in wise Administration of Ruling and constant development : A study of Arab Political
...Show More Authors

The research has been talked on specific an important notions concerning with the dimensions of effectiveness of good governance and sustainable development inside all Arab states, So that the scientific article reflected the role of investments in various sections of institutional business by draw attention toward different projects about analyzing the whole political reality according to the standard indications of political and social stability on the regional level and international aspects. Therefore, the study resembled scientific contains and the dimensions of political reform and administrative overhauling within governmental system in order to achieve all raw objectives for sustainable development. All international and

... Show More
View Publication Preview PDF
Crossref
Publication Date
Wed Oct 12 2022
Journal Name
College Of Islamic Sciences
The semantic research of Al-Maarri in his book the ulna feel and its ablution
...Show More Authors

 

Abu Al-Ala Al-Ma’arri is a linguist and writer who showed his prowess in poetry, so he had poetry collections, including “The ulna fell,” which is one of the books that attracted the attention of scholars such as (Tabrizi, Al-Khwarizmi, Al-Bateliusi and Al-Zamakhshari) .

 

To explain his language in it, the investigators’ hands finally revealed an explanation of this book, which was the work of Abu Al-Ala Al-Ma’arri himself. Those who studied the Divan (The Zind) and its explanations or the character and language of Al-Ma’arri did not pay any attention to it. Therefore, I made this research a continuation of those efforts, using semantic research as a means of revealing Al-Maarri's ef

... Show More
View Publication Preview PDF