Background:Oriental sore occurs mostly in the
mediteranian region , North Africa ,and the Middle East .
Rodents are the main reservoir for the parasite . The wet
type caused by L. major is rural and the dry type caused by
L. tropica is urban and humans are presumably the only
reservoir. Sand fly vectors are involved in all forms.
Objectives: This study aimed to show the most
important bacterial infections concomitant with cutaneous
leishmaniasis .
Methods; The study was performed on 75 patients (ages
1-50 years ) from both sexes were attending Skin Diseases
Department of Ramadi General Hospital during the period
extended from January to June 2000. These patients were
clinically diagnosed as patients with cutaneous
leishmaniasis. Skin specimens were taken for
bacteriological and parasitological investigations .The same
thing was done for specimens from 25 intact individuals
resembling the test group as negative controls.
Results: Children showed more lesions with Positive
cutaneous leishmaniasis, adult females, showed more l
lesions than adult males. Children showed more bacterial
isolates than adults, from both positive and negative l
lesions. Staphylococcal and Streptococcal isolates took the
first rank of isolation in all age groups and both sexes. E.
coli and fecal Streptococci were isolated from children
only.
Conclusion: Bacterial invasion for the skin lesion with
cutaneous leishmaniasis complicates the lesion and leads to
misdiagnosis, in addition to the delay of healing of the
lesion via bacterial end-products. There is a need for
accurate diagnostic techniques like polymerase chain
reaction (PCR) for both bacterial and parasitic agents,
suitable effective antimicrobial therapy, in addition to the
antileishmanial agents. Good sanitation of the lesion and
community education to prevent infections
Sulphated zirconia (SZ) is one of the most important solid acid catalysts was synthesize at different operating conditions, different calcination temperature and sulfonating time has been used. The prepared catalyst was distinguished by X-ray Diffraction (XRD), particle size and morphology of catalyst were checked by atomic force microscopy (AFM) and scanning electron microscopy (SEM) respectively, in addition to analysis by (DTA) Differential thermally and Energy Dispersive X-Ray (EDX). Finally, the N2 adsorption-desorption was used to measure the surface area (BET) and pore volume. High degree of tetragonal crystallinity was obtained 90 %, and surface area of 169 m2/g and pore volume of 0.39 cm3g-1 at 600°C calcination temperature for 3
... Show More
(4)
(4)
(1)
(2)
(2)
يكشف هذا المقال عن مشكلة الصفات ذات المكون الكمي والتي تعتبر واحدة من اقوى الموارد المكونة للكلمات التعبيرية والتقويمية و يتم تحليل التركيبات الدلالية ذات الاوجه المتعددة التي تنشا من عملية توظيف الصفات المشتقة بمساعدة اللواحق والتي تدل على الاتجاه العام للغات السلافية وذلك لتطوير الدلالات العاطفية والتقييمية في الكلمات ذات معنى الميزة او الخاصية يتم تقديم تعريف انماط تكوين المعاني الضمنية في دلالات
... Show More
The appearance of Mixed Mode Oscillations (MMOs) and chaotic spiking in a Light Emitting Diode (LED) with optoelectronic feedback theoretically and experimentally have been reported. The transition between periodic and chaotic mixed-mode states has been investigated by varying feedback strength. In incoherent semiconductor chaotically spiking attractors with optoelectronic feedback have been observed to be the result of canard phenomena in three-dimensional phase space (incomplete homoclinic scenarios).
This paper addresses the use of adaptive sliding mode control for the servo actuator system with friction. The adaptive sliding mode control has several advantages over traditional sliding mode control method. Firstly, the magnitude of control effort is reduced to the minimal admissible level defined by the conditions for the sliding mode to exist. Secondly, the upper bounds of uncertainties are not required to be known in advance. Therefore, adaptive sliding mode control method can be effectively implemented. The numerical simulation via MATLAB 2014a for servo actuator system with friction is investigated to confirm the effectiveness of the proposed robust adaptive sliding mode control scheme. The results clarify, after
... Show MoreBackground: Although the new treatment methods developed in recent years are aiming to minimize the need for cooperation of the patients; however, the latter still important factor the treatment. The aim of the study was to evaluate the cooperation level of Class III maloc-clusion patients with orthodontic treatment. Materials and methods: This study followed a cross-sectional style; the targeted population was patients with Class III malocclusion who were treated with three different types of orthopaedic appliances. Four questionnaires were delivered to the patient, patient’s parents, and orthodontists. Statistical analyses of the study were performed with SPSS 20.0 software. Descriptive analyses were presented using fre-quency, percenta
... Show More
(7)
(5)
Aim: To evaluate the wettability and microhardness of Zirconium (ZrO2) dental material when coated with different concentrations of Faujasite. Materials and methods: 30 circular disks produced from ZrO2, then each group is classified into 10 control groups, 10 coated groups with 3% Faujasite, and 10 coated groups with 7% faujasite by electro-spun tool to study variable properties in hardness and water contact angle of implant materials. Results: This study stated the high hardness in 7% of faujasite concentration for ZrO2, in addition, the contact angle decreased gradually until reach 0 ᵒ in 7% concentration of faujasite with ZrO2 Conclusion: Water contact angle (WCA) declined till disappeared in (7% wt.) of faujasite coated with the Z
... Show More
(8)
(7)