Background: Appreciation of the crucial role of risk factors in the development of coronary artery disease (CAD) is one of the most significant advances in the understanding of this important disease. Extensive epidemiological research has established cigarette smoking, diabetes, hyperlipidemia, and hypertension as independent risk factors for CADObjective: To determine the prevalence of the 4 conventional risk factors(cigarette smoking, diabetes, hyperlipidemia, and hypertension) among patients with CAD and to determine the correlation of Thrombolysis in Myocardial Infarction (TIMI) risk score with the extent of coronary artery disease (CAD) in patients with unstable angina /non ST elevation myocardial infarction (UA/NSTEMI).Methods: We conducted a descriptive study among 100 patients admitted with UA/NSTEMI to three major cardiac centers in Iraq: Iraqi Centre for Heart Disease ,Ibn- Al-Bitar Hospital for cardiac surgery and Al -Nasyria Cardiac Centre from January 2010 to January 2o11.Frequency of each conventional risk factors and number of conventional risk factors present among patients with CAD, compared between men and women and by age are estimated at study entry. The TIMI risk score was stratified on seven standard variables. The extent of CAD was evaluated on angiography and significant CAD was defined as ≥ 70% stenosis in any one of the three major epicardial vessels and ≥50% in LMS.Results : Among 100 patients with UA/NSTEMI , 82% of patients have one or more risk factors and only 18%of patients lacked any of 4 conventional risk factors.Smoking is the most common risk factor in male patients while diabetes mellitus and dyslipidemia are common among female patients, and all these results are statistically significant.There were 64 % patients with TIMI score < 4 (low and intermediate TIMI risk score) and 36% patients with TIMI score >4 (high TIMI risk score). Patients with TIMI score > 4 were more likely to have significant three vessel CAD and LMS versus those with TIMI risk score < 4 who have less severe disease (single and two vessel disease).Conclusion: Antecedent major CAD risk factor exposures were very common among those who developed CAD emphasizing the importance of considering all major riskfactors in determining CAD risk estimation . Patients with a high TIMI risk score were more likely to have severe multivessel CAD compared with those with low or intermediate TIMI risk score. Hence, patients with TIMI score >4 should be referred for early invasive coronary evaluation to derive clinical benefit.Key words: unstable angina , Thrombolysis in Myocardial Infarction score, risk factors
Mercury is a heavy metal that is extremely toxic. There are three types of it: inorganic, organic, and elemental. Mercury in all its forms has been shown to have harmful effects on living things. It can multiply its concentration from lower to higher trophic levels and accumulate in the body's various tissues. Aquatic organisms bodies have been exposed to mercury mostly through various human activities. The largest source of mercury pollution in the air is thermal power plants that mostly use coal as fuel. It is carried to a body of water after being deposited on the ground surface from the air. The way it enters the food chain is through aquatic plants and animals. Mercury accumulations in the kidney, liver, gills, or gonadal tissues of sp
... Show More
(1)
This research aimed to predict the permanent deformation (rutting) in conventional and rubberized asphalt mixes under repeated load conditions using the Finite Element Method (FEM). A three-dimensional (3D) model was developed to simulate the Wheel Track Testing (WTT) loading. The study was conducted using the Abaqus/Standard finite element software. The pavement slab was simulated using a nonlinear creep (time-hardening) model at 40°C. The responses of the viscoplastic model under the influence of the trapezoidal amplitude of moving wheel loadings were determined for different speeds and numbers of cycles. The results indicated that a wheel speed increase from 0.5Km/h to 1.0Km/h decreased the rut depth by about 22% and 24% in conv
... Show More
(4)
Background: Primary healthcare in Egypt has undergone significant reforms since the 1990s, including the pioneering Family Health Program (FHP). However, limited evaluation exists regarding the FHP's impact on enhancing the delivery of primary healthcare services. The primary objective of this study was to analyze and understand the efficiency and effectiveness of the FHP in altering the delivery of primary healthcare in Egypt. We aimed to outline the fundamental characteristics of the primary healthcare system, compare them between the conventional and the newly reformed FHP centers, and gauge the awareness level of these variances among key decision-makers, focusing specifically on Cairo, Egypt. Methods: This cross-sectional study employe
... Show More
In this paper, an experimental analysis of conventional air-cooled and microchannel condensers in automotive vapor compression refrigeration cycle concerning heat transfer coefficient and energy using R134a as a refrigerant was presented. The performance of two condensers and cycles tested regarding ambient temperature which it was varied from 40oC to 65oC, while the indoor temperature and load have been set to be 23oC and 2200 W respectively. Results showed that the microchannel condenser has 224 % and 77 % higher refrigerant side and air side heat transfer coefficient respectively than the coefficients of the conventional condenser. Thus, the COP, in case of using the microchannel
... Show More
(3)
The aim of this work is to enhance the mechanical properties of the glass ionomer cement GIC (dental materials) by adding Zirconium Oxide ZrO2 in both micro and nano particles. GIC were mixed with (3, 5 and 7) wt% of both ZrO2 micro and nanoparticles separately. Compressive strength (CS), biaxial flexural strength (BFS), Vickers Microhardness (VH) and wear rate losses (WR) were investigated. The maximum compression strength was 122.31 MPa with 5 wt. % ZrO2 micro particle, while 3wt% nanoparticles give highest Microhardness and biaxial flexural strength of 88.8 VHN and 35.79 MPa respectively. The minimum wear rate losses were 3.776µg/m with 7 wt. % ZrO2 nanoparticle. GIC-contai
... Show More
(16)
The electro-optic coefficient r63 and r41 are determined in congruent KDP crystals, using an experimental method based upon the direct measurement of material. Sénarmont system for electro-optic coefficient measurement and characterization of crystals was modified. This modification allowed us to obtain on the frequency dispersion dependence of the electro-optic coefficients within a frequency range up to 20 MHz and on a new version of modulation depth method. To the best of our knowledge, by using this system, the electro-optic coefficients r63 and r41 in different configurations (transverse and longitudinal) have been measured for the first time within a frequency range up to 20 MHz. The measurements have been investigated as a functi
... Show MoreKE Sharquie, AA Noaimi, SJ Murtada…, Journal of Cosmetics, Dermatological Sciences and Applications, 2016 - Cited by 4
The most significant function in oil exploration is determining the reservoir facies, which are based mostly on the primary features of rocks. Porosity, water saturation, and shale volume as well as sonic log and Bulk density are the types of input data utilized in Interactive Petrophysics software to compute rock facies. These data are used to create 15 clusters and four groups of rock facies. Furthermore, the accurate matching between core and well-log data is established by the neural network technique. In the current study, to evaluate the applicability of the cluster analysis approach, the result of rock facies from 29 wells derived from cluster analysis were utilized to redistribute the petrophysical properties for six units of Mishri
... Show MoreNecessary and sufficient conditions for the operator equation I AXAX n*, to have a real positive definite solution X are given. Based on these conditions, some properties of the operator A as well as relation between the solutions X andAare given.
Background: Powerlifters and bodybuilders use anabolic androgenic steroids (AAS) especially – as many as 55 percent of elite powerlifters admitted using these agents. In contrast to numerous documented toxic and hormonal effects of AAS their impact on the structure and function of the left ventricular (LV) was not yet fully understood.