ABSTRACTBackground: dyslipidemia plays a crucial rule in the development of cardiovascular disease, which has become the leading cause of death in most developed countries as well as in developing countries (1). The effects of reducing low density lipoprotein – C (LDL-C) concentrations on the prevention of cardiovascular events and stroke have been well reported in many clinical trials.Objectives: Evidence supports the use of statins for lipid modifications in the primary prevention of coronary artery disease, morbidity and mortality. This study aims to determine the effectiveness of atorvastatin in treating dyslipidemia in Iraqi obese patients.Methods: 200 overweight and obese patients with hypercholesterolemia, according to NCEP ATP III criteria, were included. They were randomized into 3 groups according to atorvastatin dose, 10, 20, 40 mg/ day, and treated for 8 weeks. Blood lipid profile, liver enzymes ALT and AST, urea, creatinine, uric acid, calcium and glucose were measured before and after therapy.Results: There was a significant reduction of total cholesterol (TC), Triglycerides (TG), low density lipoprotein (LDL), very low density lipoprotein (VLDL), but a non-significant reduction of high density lipoprotein (HDL) with all atorvastatin doses. The high doses of the drug caused a significant elevation of serum levels of ALT and AST and a significant decrease of blood calcium; but there was nosignificant change in blood levels ofurea, creatinine, uric acid or glucose with any dose.Conclusion: Short-term atorvastatin therapy in dyslipidemic obese patients caused a reduction of TC, TG, LDL, and VLDL, but had no significant effect on HDL, non-significant changes in blood urea, serum creatinine, serum uric acid or blood glucose, while there was a dose dependent elevation of ALT and AST
The numerical analysis was conducted to studying the influence of length to diameter ratio (L/D) on the behavior of the soil treated with sand columns treated with 8% sodium silicate for both floating and end bearing type by using finite element method (Plaxis 3D Foundation ) for isolated foundation of real dimensions. The analysis’s study indicate that in the floating type the best improvement ratio was achieved at (L/D=8) when using columns with a diameter of (0.5, 0.7), but when using columns with a diameter of 0.3 m, it was noticed that the bearing improvement ratio increases with increasing (L/d). While the results of the analysis for end bearing type show that the higher improvement ratio was achieved at (L/D=4) when using columns w
... Show MoreMany condensed polymers [A1-A7] were prepared via reaction of (Ethylenediaminetetraacetic acid = EDTA), with different prepared imide-diamines by modification [ modification of amino acids and antibiotics (B1- B7)] Imide-diamines were prepared by chlorination of L-amino acids such as [ L-Histidine, L-Alanine, L-Valine, L-Glycine and L-Aspargine ] or selected antibiotics such as [Cephallixine monohydrate and Amoxilline ] with thionyl chloride at 0°C, then reacted with ammonia to obtain imidediamines [B1-B7] . The physical properties of all prepared condensed polymers [A1-A7], new prepared diamines [B1-B7] were studied and characterized by FT -IR spectroscope to certify the structural formulas. The thermal analysis (TGA, DTA) were studied, a
... Show MoreThe research aims to identify the level of emotional reassurance and level of family climate at
the students of kindergarten Department.
Search tool :
The two researchers built a measure of emotional reassurance and consisting of (26) items and
the scale of family climate consisting of (30 ) items .
The applied Statistical methods:
The two researchers used the statistical bag spss and they used t-test and Pearson correlation
coefficient and analysis of variance and Alpha -Cronbach .
The results showed : The students of kindergarten Department have a high level of
emotional reassurance and good family climate and there is a relationship between emotional
reassurance and family climate .
The two researchers
This paper deals with modelling and control of Euler-Bernoulli smart beam interacting with a fluid medium. Several distributed piezo-patches (actuators and/or sensors) are bonded on the surface of the target beam. To model the vibrating beam properly, the effect of the piezo-patches and the hydrodynamic loads should be taken into account carefully. The partial differential equation PDE for the target oscillating beam is derived considering the piezo-actuators as input controls. Fluid forces are decomposed into two components: 1) hydrodynamic forces due to the beam oscillations, and 2) external (disturbance) hydrodynamic loads independent of beam motion. Then the PDE is discretized usi
The aim of this study was to develop a sensor based on a carbon paste electrodes (CPEs) modified with used MIP for determination of organophosphorus pesticides (OPPs). The modified electrode exhibited a significantly increased sensitivity and selectivity of (OPPs). The MIP was prepared by thermo-polymerization method using N,N-diethylaminoethymethacrylate (NNDAA) as functional monomer, N,N-1,4-phenylenediacrylamide (NNPDA) as cross-linker, the acetonitrile used as solvent and (Opps) as the template molecule. The three OPPs (diazinon, quinalphos and chlorpyrifos) were chosen as the templates, which have been selected as base analytes which used widely in agriculture sector. The extraction efficiency of the imprinted polymers has been evaluat
... Show MoreIn this study, sulfur was removed from imitation oil using oxidative desulfurization process. Silicoaluminophosphate (SAPO-11) was prepared using the hydrothermal method with a concentration of carbon nanotubes (CNT) of 0% and 7.5% at 190 °C crystallization temperature. The final molar composition of the as-prepared SAPO-11 was Al2O3: 0.93P2O5: 0.414SiO2. 4% MO/SAPO-11 was prepared using impregnation methods. The produced SAPO-11 was described using X-ray diffraction (XRD) and Brunauer-Emmet-Teller (N2 adsorption–desorption isotherms). It was found that the addition of CNT increased the crystallinity of SAPO-11. The results showed that the surface area of SAPO-11 cont
... Show MoreThe use of blended cement in concrete provides economic, energy savings, and ecological benefits, and also provides. Improvement in the properties of materials incorporating blended cements. The major aim of this investigation is to develop blended cement technology using grinded local rocks . The research includes information on constituent materials, manufacturing processes and performance characteristics of blended cements made with replacement (10 and 20) % of grinded local rocks (limestone, quartzite and porcelinite) from cement.
The main conclusion of this study was that all ty
... Show More