The research addressed an analytical field investigation of the locality of meander, the factors responsible of the locality of the meander at certain points of the stream other than others, and the role sequence of these factors in the formation process.
The research revealed that the location of forming the meander was associated closely with the scale structural composition of the bank materials from which the first stage of forming the curved stream, for the inhomogeneous or non-identical opposite banks in their scale structural composition saw an activity of differential corrosion, while the homogeneous and identical opposite banks in their scale structural composition saw an identical corrosion activity in its intensity at both banks. The research investigated in field the presence of scale variation of the materials of opposite banks in the location of forming the meander which was not found at the incurved stream banks by taking samples and analyze them in scale. The analysis results showed that the synclinal bank was with high sand ratio which was the reason behind the activity of corrosion process due to its weak cohesion, high permeability, and highroughness creating an environment of frequent turmoil reverse eddy currents. As to its opposite bank which represented the convex bank, the results of the scale analysis showed its soil to be with high content of mud; therefore, it was resistant to the corrosion activity compared to the synclinal bank, being more cohesive and of weak permeability, it was soft, so it did not create a turmoil eddy motional environment of the aquatic currents. While in the incurved stream, the results of the scale analysis showed that the soil of both opposite banks were identical in its volume content; therefore, the activity of the corrosion process was identical at both banks and its high sand ratio resulted in the expansion of the stream and not its fold.
The research revealed that the circularity of the curved stream imposed the presence of the centrifugal force which appeared in the domains of the circular motion, changing the concentration locations of the currents. As it is well-known, the fastest currents in the river are those which locate far away from the bottom and the banks, and are found in the middle of the stream which we really found in the incurved stream, but due to the control of the centrifugal force, we found that the fastest currents were concentrated at the synclinal banks and that the slowest currents were concentrated at the synclinal banks, which explains logically and realistically due to the contrast of the corrosion and sediment activity in the curved river streams and the presence of centrifugal force was responsible of the development of these streams from fold to curve to turn to cut lake.
The research defined the morphology of the curved stream at any stage of the development stages at the presence of three corrosion units that represent the synclinal banks meeting three sedimentary units represent the convex banks, two of which were opposite to each other represent overall the neck of the stream and the stream in its complete shape was represented by the overall of these corners
The aim of this study was to develop a sensor based on a carbon paste electrodes (CPEs) modified with used MIP for determination of organophosphorus pesticides (OPPs). The modified electrode exhibited a significantly increased sensitivity and selectivity of (OPPs). The MIP was prepared by thermo-polymerization method using N,N-diethylaminoethymethacrylate (NNDAA) as functional monomer, N,N-1,4-phenylenediacrylamide (NNPDA) as cross-linker, the acetonitrile used as solvent and (Opps) as the template molecule. The three OPPs (diazinon, quinalphos and chlorpyrifos) were chosen as the templates, which have been selected as base analytes which used widely in agriculture sector. The extraction efficiency of the imprinted polymers has been evaluat
... Show MoreAn experimental program was conducted to determine the residual of composite Steel Beams-Reinforced Concrete (SB-RC) deck floors fabricated from a rolled steel beam topped with a reinforced concrete slab, exposed to high temperatures (fire flame) of 300, 500, and 700ºC for 1 hour, and then allowed to cool down by leaving them in the lab condition to return to the ambient temperature. The burning results showed that, by exposing them to a fire flame of up to 300ºC, no serious permanent deflection occurred. It was also noticed that the specimen recovered 93% of 19.2 mm of the deflection caused by burning. The recovered deflection of burned composite SB-RC deck floor at 500ºC was 40% of 77.9 mm of the deflection caused by burning with a res
... Show MoreNanofluids are proven to be efficient agents for wettability alteration in subsurface applications including enhanced oil recovery (EOR). Nanofluids can also be used for CO2-storage applications where the CO2-wet rocks can be rendered strongly water-wet, however no attention has been given to this aspect in the past. Thus in this work we presents contact angle (θ) measurements for CO2/brine/calcite system as function of pressure (0.1 MPa, 5 MPa, 10 MPa, 15 MPa, and 20 MPa), temperature (23 °C, 50 °C and 70 °C), and salinity (0, 5, 10, 15, and 20% NaCl) before and after nano-treatment to address the wettability alteration efficiency. Moreover, the effect of treatment pressure and temperature, treatment fluid concentration (SiO2 wt%) and
... Show MorePortland Cement is manufactured by adding 3% gypsum to clinker which is produced by grinding, pulverizing, mixing, and then burning a raw mix of silica, and calcium carbonate. Limestone is the main source of carbonates, while clay collected from arable land is the main source of silica. The marl in the Euphrates Formation was studied as an alternative to arable lands. Nine boreholes drilled and penetrated the marl layer in selected locations at the Kufa cement quarry. Forty-one samples of marl from boreholes and four samples of limestone from the closed area were collected. The chemical content of the major oxides and the hardness of the marl layer was very encouraging as a raw material for Portland Cement as they are SiO2 (17.60),
... Show MoreThe species of Opilio kakunini Snegovaya, Cokendolpher & Mozaffarian, 2018 was recorded for the first time in Iraq; as well as to four species belonging to this order which were recorded previously. In this paper, we added a new species to the checklist of Iraqi opilionid fauna with a description of the most important characteristics, along with genitalia, for both males and females are presented with digital photographs. Specimens of males and females were collected from Al- Rifai district northern of Dhi-Qar Province, southern of Iraq.
Neuro-ophthalmic disorders are often documented individually for each illness, with little data available on their overall incidence and pattern. The overall incidence of neuro-ophthalmic illnesses in Iraq is still not recorded. This study aimed to evaluate the clinical, demographic, and etiological features of patients seeking consultation at an Iraqi neuro-ophthalmology clinic. A prospective cross-sectional observational research was conducted at the Janna Ophthalmic Center in Baghdad, Iraq. The center serves a diverse patient population from various governorates. All newly diagnosed patients with neuro-ophthalmic disorders who visited the neuro-ophthalmological clinic, regardless of gender or age group, were included. The neuro-ophthalmo
... Show MoreThe Al-Kindy College Medical Journal (KCMJ) is an Iraqi scholarly journal published by the Al-Kindy College of Medicine, University of Baghdad. It was officially founded in 2004. It is a peer-reviewed journal, published in both online and printed forms. It has a mission to offer a publication platform that mirrors recent knowledge and findings in the field of medicine and medical sciences. It publishes various types of articles, including editorial, review article, research article, brief report, case report, and letter to editor. It accepts articles in the English language. It was biannually published till 2021 when it started to launch three issues per year. The journal is registered with numerous partners, including Iraqi Academi
... Show MoreThe aim of this study is to know the effect of using locally manufactured fishmeal and its nutritional value note that its manufactured from uneconomical local fish are not for human consumption. Cyprinus carpio fed with three different diets levels of locally manufactured fishmeal at a rate of 0.03 and 0.05 of the body weight. For control treatment (C1), the second treatment (C2) and the third treatment (C3). It was found that the C3 was superior to the first two parameters, control (C1) and (C2), in most of the studied standards with a high significance level (P≥0.05). The average final weight of the fish in the third parameter (C3) was 7.75g. The daily growth rate (DGR) of the th