It is well known that petroleum refineries are considered the largest generator of oily sludge which may cause serious threats to the environment if disposed of without treatment. Throughout the present research, it can be said that a hybrid process including ultrasonic treatment coupled with froth floatation has been shown as a green efficient treatment of oily sludge waste from the bottom of crude oil tanks in Al-Daura refinery and able to get high yield of base oil recovery which is 65% at the optimum operating conditions (treatment time = 30 min, ultrasonic wave amplitude = 60 micron, and (solvent: oily sludge) ratio = 4). Experimental results showed that 83% of the solvent used was recovered meanwhile the main water

The aim of the current research is to identify the impact of the SWOT strategy on developing systemic intelligence among students of the Ibn Rushd College of Education for Human Sciences University of Baghdad / College of Education Ibn Rushd for Human Sciences. The current research community consists of (8590) male and female students, divided into (7) departments. The current research relied on one of the partial control designs, which is the design of non-random groups: experimental group and a control group with a pre and post-test. As for the research tool, It was represented by Tourmanin’s Systemic Intelligence Scale (2012) of (50) items that measure the eight components of systemic intelligence. The results of the Mann Whitney te

In this research the effect of cooling rate and mold type on mechanical properties of the eutectic
and hypoeutectic (Al-Si) alloys has been studied. The alloys used in this research work were (Al- 12.6%Si
alloy) and (Al- 7%Si alloy).The two alloys have been melted and poured in two types of molds with
different cooling rates. One of them was a sand mold and the other was metal mold. Mechanical tests
(hardness, tensile test and impact test) were carried out on the specimens. Also the metallographic
examination was performed.
It has been found that the values of hardness for the alloys(Al-12.6%Si and Al-7%Si) which poured in
metal mold is greater than the values of hardness for the same alloy when it poured in a heated

In this study; a three-dimensional model was created to simulate groundwater in Al-Haydariyah area of the governorate of Al-Najaf. A solid model was created to utilize the cross sections of 25 boreholes in the research region, and it was made out of two layers: sand and clay. The steady-state calibration was employed in six observation wells to calibrate the model and establish the hydraulic conductivity, which was 17.49 m/d for sand and 1.042 m/d for clay, with a recharge rate of 0.00007 m/day. The wells in the research region were reallocated with a distance of 1500 m between each well, resulting in 140 wells evenly distributed throughout the study area and with a discharge of 5 l/s, and the scenarios were run for 1000

The investigation of the effect of tempering on thermal analysis of
Al-Ti-Si alloy and its composites with MgO and SiC particles was
performed. Thermal analysis was performed before and after
tempering by DSC scan. Optical microscopy was used to identify the
phases and precipitations that may be formed in base alloy and
composites. X-ray diffraction test indicated that the Al3Ti is the main
phase in Al-Ti-Si alloy in addition to form Al5Ti7Si12 phase. Some
chemical reactions can be occurred between reinforcements and
matrix such as MgO.Al2O3 in Al-Ti/MgO, and Al4C3 and Al(OH)3 in
Al-Ti/SiC composite. X-ray florescence technique is used to
investigate the chemical composition of the fabricated specimens.
H

In current research Copper was employed for preparing a ternary system of Al–Si alloy in different (0.2–2.5 wt. %) the best was taken is (1.5%wt) of copper that circumstances of solidification for improving the mechanical performance of the available in aluminium alloy. Cast iron molds were prepared to obtain tensile strength testing specimens. Alloys were prepared by employing gas furnaces. The molten metal was poured into a preheated cast-iron mold. The obtained alloy structures were studied using an X-ray diffractometer and optical microscopy. The mechanical performance of the prepared alloys was examined under the influence of different hardening conditions in both heat and non-heat-treated conditions. The outcomes showed at the

Al-Chibayish Marsh (CM)  is considered as the major part of Central Marshes area of this marsh is 1050 Km². The water quality of these marshes is suffering from salt accumulation due to intensive dam construction, limited supply of water from sources,  climate change impacts, and the absence of outlet flow from these marshes, specifically at low flow periods. So, the current research aims to assess and improve these marshes' hydraulic behavior and water quality and define the best location for outlet drains.  Field measurements and laboratory tests were conducted for two periods (November 2020 and February 2021) to define the (TDS) concentrations at nine different locations. Samples were also examined for water's phy

Whatever the designers of the advertisement in choosing the text and spoken phrases, those phrases cannot give or convey the full meaning to the recipient only if this spoken and written language is reinforced with another language based on the signals, movements, and symbols that are displayed using the body or other artistic elements of the advertisement such as pictures, colors, music, effects, and other elements used in the artistic construction of television advertising. All these artistic elements contribute to the completion of the advertising idea and make it ready to be displayed to the public.

Scientists and researchers, in the field of psychology, have relied a lot on this language (body language). And some of them put

The use of the Iraqi song in the symphony orchestra is one of the pioneering and important works, which carries with it an artistic value of aesthetic specificity in how to use the Iraqi singing heritage. The research aimed to identify the employment of the song (Foug Al-Nakhl) and its works within the Iraqi national symphony orchestra music by the author Hans Count Momer whose works still have a great influence on the authors of the Iraqi orchestra.  The researcher presented a brief introduction to the Iraqi Symphony Orchestra, a brief introduction about the author, and the trends of world music towards heritage. He also talked about musical composition, research procedures and tools, and applying the tool to the selected sample (F