The effect of the initial pressure upon the laminar flame speed, for a methane-air mixtures, has been detected paractically, for a wide range of equivalence ratio. In this work, a measurement system is designed in order to measure the laminar flame speed using a constant volume method with a thermocouples technique. The laminar  burning velocity is measured, by using the density ratio method. The comparison of the present work results and the previous ones show good agreement between them. This indicates that the measurements and the calculations employed in the present work are successful and precise

The optical absorption data of Hydrogenated Amorphous Silicon was analyzed using a Dunstan model of optical absorption in amorphous semiconductors. This model introduces disorder into the band-band absorption through a linear exponential distribution of local energy gaps, and it accounts for both the Urbach and Tauc regions of the optical absorption edge.Compared to other models of similar bases, such as the O’Leary and Guerra models, it is simpler to understand mathematically and has a physical meaning. The optical absorption data of Jackson et al and Maurer et al were successfully interpreted using Dunstan’s model. Useful physical parameters are extracted especially the band to the band energy gap , which is the energy gap in the a

Tax fraud is following different methods of tax evasion (bypassing the laws, instructions and regulations related to tax) by not showing the real taxable income by using laws, instructions and regulations improperly, and because of the weak basic role of forensic accounting in detecting and reducing tax fraud, the problem has become more influential on the state general tax income. The main objective of the research is to identify forensic accounting and the extent to how it can be applied in the General Tax Authority to assist forensic authorities in issuing judgments in fraud cases. To achieve the objectives of the research, the descriptive analytical approach was used to reach the topic of the research, and a questionnaire (co

A Forensic Accounting is represent science that deals with the application of knowledge in the areas of accounting, finance, tax and audit for the analysis, investigation, inquiry, inspection and testing issues in the civil law and criminal law in an attempt to reach the truth through which enable the Forensic Accountant to provide his Expert opinion , forensic accounting plays a major role by providing a range of important services in the field of investigation for fraud and litigation support, As one of the most important legal and accounting functions is to investigate allegations of alleged by the related parties, especially those allegations related to the existence of fraud, since the goal of judicial accountant will depend

The efficient behavior of a low-concentrating photovoltaic-thermal system with a micro-jet channel (LCPV/T-JET) and booster mirror reflector is experimentally evaluated here. Micro-jets promote the thermal management of PV solar cells by implementing jet water as active cooling, which is still in the early stages of development. The booster mirror reflector concentrates solar irradiance into solar cells and improves the thermal, electrical, and combined efficiencies of the LCPV/T-JET system. The LCPV/T-JET system was tested under ambient weather conditions in the city of Bangi, Selangor, Malaysia, and all data was recorded between 10:00 a.m. and 4:00 p.m. Parametric studies were conducted to compare the performance of the LCPV/T-JET system

The present work focuses on the experimental implementation of one of the fiber optical sensors, the optical glass fiber built on surface Plasmon resonance. A type of optical glass fiber was used in this work, single-mode no-core fiber with pre-tapering diameter: (125.1 μm) and (125.3 μm), respectively. The taper method can be tested by measuring the output power of the optical fiber before and after chemical etching to show the difference in cladding diameter due to the effect of hydrofluoric acid with increasing time for the taper process. The optical glass fiber sensor can be fabricated using the taper method to reduce the cladding diameter of the fibers to (83.12 µm, 64.37 µm, and 52.45 µm) for single-mode fibers using Hydrofluoric