Background: disruptive behavioral disorders among primary school children is oone of the most popular, which has negative social, psychological, educational, and physical repercussions on children and families. Objective: This study sought to determine effect disruptive behavioral disorders quality of learning among school chil dren. Methods: A descriptive cross-sectional design study was conducted at Baquba primary schools in Diyala Governorate, and the study period was extended from October 6th, 2024, to January 15th, 2025. A nonprobability purposive sample was used to include 275 teachers working at selected Baquba primary schools, Iraq. Data were collected using a self-admin istered questionnaire, two components of the study instruments. Initially, the demographic sheet contained the individ uals’ sociodemographic data. An explicit children’s emotional and behavioral problems scale is included in the second section. The collected data were analysed using SPSS version 26. Results: The results showed that areas were within a moderate disruptive behavior level for: aggression, hyperactiv ity, and learning problems, and area was within a low disruptive behavior level for Physical problems. The average scores for these areas are 2.05, 2.39, 2.30, 1.52 respectively and total average scores for these areas is (2.16). The findings demonstrated a robust and positive association between the age group and disruptive behavior disorders among primary schools’ children. However, the statistical analysis indicated that there was significant correlation between sociodemo graphic factors and DBD regarding of gender. Conclusion: In summary, students with disruptive behavioral disorders have lower academic achievement and gradu ation rates than students without disabilities. The majority of the children polled in this study reported moderate levels of DBD.
Nanofluids are proven to be efficient agents for wettability alteration in subsurface applications including enhanced oil recovery (EOR). Nanofluids can also be used for CO2-storage applications where the CO2-wet rocks can be rendered strongly water-wet, however no attention has been given to this aspect in the past. Thus in this work we presents contact angle (θ) measurements for CO2/brine/calcite system as function of pressure (0.1 MPa, 5 MPa, 10 MPa, 15 MPa, and 20 MPa), temperature (23 °C, 50 °C and 70 °C), and salinity (0, 5, 10, 15, and 20% NaCl) before and after nano-treatment to address the wettability alteration efficiency. Moreover, the effect of treatment pressure and temperature, treatment fluid concentration (SiO2 wt%) and
... Show MoreThe D.C electrical and thermoelectrically properties of randomly mixed isolator – electrolyte system as (Al/ PVC – LiF/Al) junction consisting of polyvinyl chloride (PVC)resin reinforced with Lithium Fluoride (LiF) powder were studied. A comparison is made the properties of (PVC) material with varying percentage of (LiF) powder (0%, 30%, 50%, 80%)to find out the effect of reinforcement of isolator material. The composites dissolving in 10ml form tettraHaedroflourn (THF) and Solution were the castled in Petri dish and Laved it dry in the air, The out coming Sample were disc - Like shape of a diameter of about 3cm and thickness reneged between (0.01- 0.018) cm . The composites dissolving in 10ml form tettraHaedroflourn (THF) a
... Show MoreKE Sharquie, KI Al-Hamdi, AA Noaimi, AA Al-Mohammadi, J Clin Exp Invest www. clinexpinvest. org Vol, 2011 - Cited by 1
Portland Cement is manufactured by adding 3% gypsum to clinker which is produced by grinding, pulverizing, mixing, and then burning a raw mix of silica, and calcium carbonate. Limestone is the main source of carbonates, while clay collected from arable land is the main source of silica. The marl in the Euphrates Formation was studied as an alternative to arable lands. Nine boreholes drilled and penetrated the marl layer in selected locations at the Kufa cement quarry. Forty-one samples of marl from boreholes and four samples of limestone from the closed area were collected. The chemical content of the major oxides and the hardness of the marl layer was very encouraging as a raw material for Portland Cement as they are SiO2 (17.60),
... Show MoreAntibacterial Activity of Bioactive Glass 45S5 and Chitosan Incorporated as Fillers into Gutta Percha, Ahmed I AL-Jobory*, Raghad AL-Hashimi
In earthquake engineering problems, uncertainty exists not only in the seismic excitations but also in the structure's parameters. This study investigates the influence of structural geometry, elastic modulus, mass density, and section dimension uncertainty on the stochastic earthquake response of a multi-story moment resisting frame subjected to random ground motion. The North-south component of the Ali Gharbi earthquake in 2012, Iraq, is selected as ground excitation. Using the power spectral density function (PSD), the two-dimensional finite element model of the moment resisting frame's base motion is modified to account for random ground motion. The probabilistic study of the moment resisting frame structure using stochastic fin
... Show MoreHuman Adenosine deaminase is an essential enzyme for modulating the bioactivity of thyroid hormones, and It is important for the maturation and differentiation of lymphocytes, although its clinical importance in thyroid diseases have yet to be identified. Objective: The aim of the current study is to determine the Adenosine deaminase concentration in healthy controls, and in autoimmune thyroid diseases such as Graves' Disease, and Hashimoto's Thyroiditis. Patients and methods: A total of 183 serum specimens of 103 female patients with autoimmune thyroid diseases and 80 healthy control groups were included in this study and collected from the Baghdad Medical City, Iraq. Quantitative Human Adenosine Deaminase ELISA kits were used to estimate
... Show MoreA nanocrystalline thin films of PbS with different thickness (400, 600)nm have been prepared successfully by chemical bath deposition technique on glass and Si substrates. The structure and morphology of these films were studied by X-ray diffraction and atomic force microscope. It shows that the structure is polycrystalline and the average crystallite size has been measured. The electrical properties of these films have been studied, it was observed that D.C conductivity at room temperature increases with the increase of thickness, From Hall measurements the conductivity for all samples of PbS films is p-type. Carrier's concentration, mobility and drift velocity increases with increasing of thickness. Also p-PbS/n-Si heterojunction has been
... Show More