This study investigates the analytical approach of web reinforcement techniques, including high-strength concrete and laced reinforcement, to enrich improvement for the structural behavior of these beams. The analysis compares an unmodified cellular beam (LB1) with a web-reinforced beam (LB2), including the improvements in load-carrying capacity. The study considers the effects of reinforcement on critical design limit states, such as flexural strength, Vierendeel bending, web post-buckling, and shear resistance. The outcomes reveal significant enhancements in LB2’s structural behavior, with over a 100% increase in flexural strength and local axial force capacity and a 165% increase in web post-buckling strength. This research validates the effectiveness of web reinforcement techniques in concentrating on the limitations of cellular beams and maximizing their potential in structural applications.
For the design of a deep foundation, piles are presumed to transfer the axial and lateral loads into the ground. However, the effects of the combined loads are generally ignored in engineering practice since there are uncertainties to the precise definition of soil–pile interactions. Hence, for technical discussions of the soil–pile interactions due to dynamic loads, a three-dimensional finite element model was developed to evaluate the soil pile performance based on the 1 g shaking table test. The static loads consisted of 50% of the allowable vertical pile capacity and 50% of the allowable lateral pile capacity. The dynamic loads were taken from the recorded data of the Kobe e
Compounds of (ZnO)1-x(SnO 2 ) x were prepared with various proportions of tin oxide (SiO 2) (x = 0.0, 0.2, 0.4, 0.6, 0.8, 1.0) by mixing zinc oxide (ZnO) with highpurity tin oxide and then sintering the mixture in an oven at a temperature of 1000 °C for a period of 1 h. The resulting powders were ground and pressed into tablets of 1 cm diameter and 0.5 cm thickness. The properties of (ZnO) 1-x(SnO 2 ) x composites flms were prepared and studied as sensitive to the diferent gases NO2 and H2 S. Thin flms were prepared from (ZnO) 1-x(SnO 2 ) x via pulsed laser deposition method using glass and single crystal silicon for investigation the morphology and gas sensing properties with a thickness of 150 nm. The morphology examinat
... Show Moreew sports technologies have highlighted the importance of perceptual – cognitive training in order to optimize performance in sports e.g., dynamic team sport such as basketball. Augmented motor reality AMR is a new training model based on realistic movement combined with interactive virtual cues that may be useful to enhance spatial orientation and decision making. The purpose of this study was to investigate the effects of an AMR-based training program on spatial awareness and skill-based decision making in youth basketball players. Twenty-four male young basketball players aged 15.2±0.8 years were randomized to the experimental group n=12, receiving AMR training, and control group n=12, performing conventional practice. The interventio
... Show MoreLowering specific energy consumption (SEC) in reverse osmosis (RO) plants is one of the most important criteria in water treatment industry. The present work focused on best suggested RO pilot plant configurations for minimizing specific energy consumption, finding the best configurations experimentally to recover the water with minimizing salts in permeate side in RO module, study the factors affecting the performance of single and two stage systems, TFC membrane is used in spiral wound module. Brackish water is used as feed solution with different concentrations (2000, 3000, 4000 and 5000 ppm). The operating parameters studied were permeate flux, rejection and SEC. The experimental results showed the permeate concentration increased and w
... Show MorePoly(ethylene oxide) is a promising material for solid-state lithium batteries due to its safety, ease of processing, and compatibility with lithium. However, conventional linear PEO falls short of practical requirements due to its limited ionic conductivity, a consequence of the high crystallinity of its ethylene oxide chains. This crystallinity hinders the movement of lithium ions, limiting its performance in solid-state battery applications. In this study, we successfully prepared the plasticized solid polymer electrolytes (PSPEs) based on poly(ethylene oxide) (PEO)/ tetracyanoethylene (TCE) complexed with lithium bis(trifluoromethanesulfonyl)imide (LiTFSI) salt and studied the effect of TCE on structural, mechanical, electrical and elec
... Show MoreThis study compared the effects of citric acid (CA) derived from microbial fermentation using Aspergillus niger (400 mg kg-1) and natural extraction from Citrus limon (400 mg kg1) in albino mice. Parameters assessed included cytogenetic damage via the micronucleus (MN) assay, immunological response through immunoglobulin (IgA, IgG, IgM) titers, and hepatoprotective activity based on liver enzyme levels (AST, ALT, ALP) and histopathological inves tigation. Mice were divided into six groups (n=10/group) as follows: (1) negative control, (2) carbon tetrachloride (CCl₄ 0.02%), (3) lemon CA, (4) A. niger, (5) CCl₄ + lemon CA, and (6) CCl₄ + A. niger CA. The CCl4 group exhibited a significantly higher MN frequency (0.06 ± 0.008) compa
... Show MoreNew sports technologies have highlighted the importance of perceptual – cognitive training in order to optimize performance in sports e.g., dynamic team sport such as basketball. Augmented motor reality AMR is a new training model based on realistic movement combined with interactive virtual cues that may be useful to enhance spatial orientation and decision making. The purpose of this study was to investigate the effects of an AMR-based training program on spatial awareness and skill-based decision making in youth basketball players. Twenty-four male young basketball players aged 15.2±0.8 years were randomized to the experimental group n=12, receiving AMR training, and control group n=12, performing conventional practice. The interventi
... Show MoreThis study presents the design, modeling, and experimental evaluation of a three-level electro-hydraulic elevator system controlled by a Delta DVP-20SX2 Programmable Logic Controller (PLC) equipped with an integrated Proportional–Integral–Derivative (PID) module. The PLC, programmed in Ladder Logic using ISPSoft 2.46, regulates cabin motion across all three levels. A detailed MATLAB/Simulink model was developed, incorporating three PID controllers: one for displacement regulation via a proportional directional control valve and two for dynamic pressure regulation using a proportional pressure relief valve. Conventional PID parameters were initially tuned using the trial-and-error method based on time-domain performance indices a
... Show More