Rare-earth metal oxides (REMOs) exhibit distinctive properties, among which cerium oxide (CeO2) displays numerous industrial, technological, and medical applications. However, the inclusion of hafnium (Hf) at the cerium (Ce) site to form the (Ce1-ₓHfₓO2) lattice system at a concentration of x = 0.25 would have an impact on enhancing the physical properties of the simulated configuration. Density functional theory (DFT) was used to perform the calculations, supported by the Hubbard correction factor (U). The generalized gradient approximation (GGA-PBE) was employed to analyze the electronic, structural, optical, and mechanical properties at hydrostatic pressures (P = 0, 25, 50, 75, and 100 GPa). The ground state geometry of the pristine fluorite CeO2 corresponds to 5.438 Å, signifying an excellent agreement with the available published literature. The calculated lattice parameter of Ce0.75Hf0.25O2 is diminished to 5.327 Å as compared with CeO2. Furthermore, CeO2 exhibits a semiconductor character with a direct band gap of 3.134 eV, while the band gap of the Ce0.75Hf0.25O2 system was reported to be 3.073 eV, demonstrating slight degradation. However, under pressure, the results demonstrate a gradual increment in the band gap energy of Ce0.75Hf0.25O2 until reaching 3.861 eV at 100 GPa. Furthermore, the thermodynamic feasibility was investigated via the chemical potential approach. The pressure-dependent optical properties were extensively discussed of Ce0.75Hf0.25O2, demonstrating enhanced optical properties in the ultraviolet (UV) region, motivating its suitable utility for optoelectronic memristors and other photonic applications.
The CdSe pure films and doping with Cu (0.5, 1.5, 2.5, 4.0wt%) of thickness 0.9μm have been prepared by thermal evaporation technique on glass substrate. Annealing for all the prepared films have been achieved at 523K in vacuum to get good properties of the films. The effect of Cu concentration on some of the electrical properties such as D.C conductivity and Hall effect has been studied.
It has been found that the increase in Cu concentration caused increase in d.c conductivity for pure CdSe 3.75×10-4(Ω.cm)-1 at room temperatures to maximum value of 0.769(Ω.cm)-1 for 4wt%Cu.All films have shown two activation energies, where these value decreases with increasing doping ratio. The maximum value of activation energy was (0.319)eV f
Films of CdSe have been prepared by evaporation technique with thickness 1µm. Doping with Cu was achieved using annealing under argon atmosphere . The Structure properties of these films are investigated by X-ray diffraction analysis. The effect of Cu doping on the orientation , relative intensity, grain size and the lattice constant has been studied. The pure CdSe films have been found consist of amorphous structure with very small peak at (002) plane. The films were polycrystalline for doped CdSe with (1&2wt%) Cu contents and with lattice constant (a=3.741,c=7.096)A°, and it has better crystallinty as the Cu contents increased to (3&5wt%) Cu. The reflections from [(002), (102). (110), (112), and (201)]planes are more prominen
... Show MoreThe research aims to identify the level of selective visual attention among students of the faculties of education at the University of Mosul. To achieve the goal of the research, the researchers chose a stratified random sample of students from the faculties of education at the University of Mosul for the academic year (2020-2021). The sample size was (652) students from the scientific and humanitarian specializations, the second and fourth stages. The researchers developed a test of multiple-choice to measure the selective visual attention, which consisted of (42) items. The results revealed that the students of the faculties of education for human sciences have an appropriate level of selective visual attention. There are statisticall
... Show MoreIn this research, damping properties for composite materials were evaluated using logarithmic decrement method to study the effect of reinforcements on the damping ratio of the epoxy matrix. Three stages of composites were prepared in this research. The first stage included preparing binary blends of epoxy (EP) and different weight percentages of polysulfide rubber (PSR) (0%, 2.5%, 5%, 7.5% and 10%). It was found that the weight percentage 5% of polysulfide was the best percentage, which gives the best mechanical properties for the blend matrix. The advantage of this blend matrix is that; it mediates between the brittle properties of epoxy and the flexible properties of a blend matrix with the highest percentage of PSR. The second stage
... Show MoreMatrix acidizing is a good stimulation process in which acid is introduced into the reservoir near the wellbore area via the wellbore or coil tubing. In the oil industry, formation damage is a prevalent problem. Bypassing wellbore damage by producing wormholes in carbonate reservoirs is the main purpose of acidizing the matrix of the formation. When doing lab tests, scientists are looking for a wormhole-inducing injection rate that can be used in the field. Meantime the ongoing works on the Ahdeb oil field's Mishrif reservoir, several reports have documented the difficulties encountered during stimulation operations, including high injection pressures that make it difficult to inject acid into the reservoir formation; and only a few
... Show MoreIn this work, the possibility of a multiwavelength mode-locked fiber laser generation based on Four-Wave Mixing (FWM) induced by Fe2O3-SiO2 nanocomposite material is investigated for the first time. A multiwavelength mode-locked pulses fiber laser are generated from Ytterbium–doped fiber laser (YDFL) due to the combined action of high nonlinear absorption and high refractive coefficients of Fe2O3-SiO2 nanocomposite incorporated inside YDFL ring cavity. Up to more than 20 lasing lines in the 1040–1070 nm band with an equally lines separation of ~0.6 nm have been observed by just simple variation of passive modulation of the state of the polarization and the pump power altogether. Moreover, a passively mode-locked operation of YDFL laser
... Show MoreThe research aims to a statement of specificity of the Controller of (academic achievement, specialty, job title, length of service, Gender) and its impact on performance, Through a proposed appraisal form includes three main axes and each axis including several specialized elements in the supervisory work in form (check list). as is the importance of research to enable officials of oversight bodies financial identify and diagnose performance Controller through what has this observer of the process of scientific properties when performing supervisory work. Be summarized problem of the research that the lack of regulatory institution with the Controller interesting in terms of the necessary characteristics and requirements and inv
... Show MoreInsurance actions has become a task of the vital foundations on which the international economy depends, where its presence helped in the development of economic resources in which human resource is considered the most important of these resources. Insurance companies play the biggest role in protecting this resource and minimizing the impact of the dangers that verify this condition.Human has worked hard to get rid of the dangers and its harm, and to devise many ways to prevent them. A risk management is considered within human’s creations in order to create a society with fewer negative risks impacts.
On this basis, th
... Show MoreThis study aims to show some of Imam Al-Bukhari's criticism of the Hadith from the Metn side, and part of his methodology in dealing with the correct hadiths that are tainted by a bug. This research focuses on what Imam Al-Bukhari summarized in his Sahih illusion of the narrator in his attribution, or uniqueness of the narrator, or to suggest a novel. We find that Bukhari sometimes abbreviates the hadeeth, and does not bring it out completely in his Sahih. He is satisfied with the abbreviated position but has done so because of a bug in it. The Bukhari usually does not declare his intention but knows this through tracking, inspection, and research of the correct hadiths.
The research aims to determine the role of knowledge management to measure performance on a sample of faculties of Administration and Economics the University of Kufa, and to achieve this goal through a researcher from the theoretical literature and research and studies related to the construction of the scheme shows the hypothetical relationship between the variables, which was adopted by the independent variable knowledge management, distributed four variables are: (knowledge generation, knowledge storage, knowledge dissemination, the application of knowledge), as well as four variables representing the variables adopted for the performance of the university are:
(to reduce costs and increase profits, improve quality, scie