The current study was conducted with the aim of fortifying meat burger with the protein isolate extracted from defatted sweetened and unsweetened apricot kernels. The antimicrobial activity of defatted apricot kernels and protein isolates of sweetened and unsweetened kernels against some pathogenic microbes was studied, and it was characterized by its effect on gram-positive bacteria more than gram-negative bacteria. As for its effect on yeast, the inhibition diameter was 4.5 mm at a concentration of 200 mg for the unsweetened protein isolate. As for its effect on mold, the inhibition percentage was between 56.05 65.21% for all samples at a concentration of 100 mg. The sweetened and unsweetened protein isolate was used in the manufacture of meat burger with a replacement rate of 5%, 10% and 20%, and the shrinkage ratio was measured by diameter of the burger, where the best shrinkage rate was in the burger replaced with 20% of the sweetened isolate, which was 16.25% compared to the control model 18.75%, and the holding capacity of water and fat was measured, and burger which replaced with unsweetened isolate gave the highest value. The number of microorganisms was also measured and a sensory evaluation was conducted for these models. All samples were similar to the control model until 20% of the local sweetened protein isolate was replaced.
This study aimed at evaluating the torsional capacity of reinforced concrete (RC) beams externally wrapped with fiber reinforced polymer (FRP) materials. An analytical model was described and used as a new computational procedure based on the softened truss model (STM) to predict the torsional behavior of RC beams strengthened with FRP. The proposed analytical model was validated with the existing experimental data for rectangular sections strengthened with FRP materials and considering torque-twist relationship and crack pattern at failure. The confined concrete behavior, in the case of FRP wrapping, was considered in the constitutive laws of concrete in the model. Then, an efficient algorithm was developed in MATLAB environment t
... Show MoreReliability analysis methods are used to evaluate the safety of reinforced concrete structures by evaluating the limit state function 𝑔(𝑋𝑖). For implicit limit state function and nonlinear analysis , an advanced reliability analysis methods are needed. Monte Carlo simulation (MCS) can be used in this case however, as the number of input variables increases, the time required for MCS also increases, making it a time consuming method especially for complex problems with implicit performance functions. In such cases, MCS-based FORM (First Order Reliability Method) and Artificial Neural Network-based FORM (ANN FORM) have been proposed as alternatives. However, it is important to note that both MCS-FORM and ANN-FORM can also be time-con
... Show MoreIn this study, the first kind Bessel function was used to solve Kepler equation for an elliptical orbiting satellite. It is a classical method that gives a direct solution for calculation of the eccentric anomaly. It was solved for one period from (M=0-360)° with an eccentricity of (e=0-1) and the number of terms from (N=1-10). Also, the error in the representation of the first kind Bessel function was calculated. The results indicated that for eccentricity of (0.1-0.4) and (N = 1-10), the values of eccentric anomaly gave a good result as compared with the exact solution. Besides, the obtained eccentric anomaly values were unaffected by increasing the number of terms (N = 6-10) for eccentricities (0.8 and 0.9). The Bessel
... Show MoreAqueous Two Phase System (ATPS) or liquid-liquid extraction is used in biotechnology to recover valuable compounds from raw sources. In Aqueous Two-Phase Systems, many factors influence the Partition coefficient, K, (which is the ratio of protein concentration in the top phase to that in the bottom phase) and the Recovery percentage (Rec%). In this research, two systems of ATPS were used: first, polyethylene glycol (PEG) 4000/Sodium citrate (SC), and the second, PEG8000/ Sodium phosphate (SPH), for the extraction of Bovine Serum Albumin (BSA). The behavior of Rec% and K of pure (BSA) in ATPS has been investigated throughout the study by the effects of five parameters: temperature, concentration of polyethylene glycol (P
... Show More