Preferred Language
Articles
/
4xbbuosBVTCNdQwCBthw
Effects of Pressure and Moisture Content on Bulk Density of Triticale Grain under Compaction
...Show More Authors

Highlights

Compaction of triticale grain with three moisture contents (8%, 12%, and 16% wet basis) was measured at five applied pressures (0, 7, 14, 34, and 55 kPa).

Bulk density increased with increasing pressure for all moisture contents and was significantly (p < 0.0001) dependent on both moisture content and applied pressure.

A Verhulst logistic equation was found to model the changes in bulk density of triticale grain with R2 of 0.986.

The model showed similar behavior to that of wheat and rye, indicating that the results of this study can be used with the methods of ASABE Standard S413 to predict the quantity of triticale grain stored in bins.

Abstract. The objective of this study was to determine the combined effects of moisture content (MC) and pressure on the changes in bulk density of triticale grain under compaction at conditions typical of those seen in storage structures and to develop mathematical models to describe the compression behavior. Triticale compaction was measured at three MCs (8%, 12%, and 16% wet basis) and four compaction pressures (7, 14, 34, and 55 kPa) using a square metal box based on the design used in an earlier study by Thompson and Ross. Data from the compaction tests were used to calculate bulk densities for the three MCs and four pressures. Bulk densities were found to be significantly (p < 0.0001) dependent on both MC and pressure. Bulk densities varied with increasing MC, as has been observed in similar studies for other agricultural grains such as rye and wheat. These results provide guidance for estimating the bulk density of triticale in bins and other storage structures. The Verhulst logistic equation was found to best describe the changes in bulk density of triticale caused by rearrangement of the grain kernels at lower pressures for the three MCs. At higher pressures, the grain was observed to be more compliant, and Hooke’s law was used to accurately describe the observed changes. Data from the compaction tests were used to estimate the model parameters, with a correlation coefficient (R2) of 0.986. The model was then used in WPACKING to compare the results of this study to pack factor predictions for triticale and wheat. WPACKING is a computer program that is the basis for ASABE Standard S413. The results of this comparison showed that this method can be used with the methods of ASABE Standard S413 to predict the quantity of triticale grain stored in bins. Keywords: Bulk density, Interaction, Moisture content, Pressure, Triticale, Verhulst logistic equation.

Scopus Clarivate Crossref
View Publication
Publication Date
Sat Jan 01 2022
Journal Name
Journal Of Pharmaceutical Negative Results
Environmental effects on intestinal parasitic disease transmission in Mosul governorate
...Show More Authors

This study, which was conducted in the city of Mosul, through collected 1200 samples from the stool of patients with diarrhea attending hospitals and private clinics for the period from the beginning of January 2019 to the end of December 2019, those whose ages ranged from less than a year-60 year, and for both sexes and by reality 700 samples stool for males and 500 samples stool for females. Samples were collected in clean, sterile, and sealed 40ml plastic bottles. Patient information is noted, name of the parasite, history, sex, age, address. The result showed that climate and temperature have a significant effect on increase the incidence of intestinal parasites through the direct effect on the increase in infection rate. This effect wa

... Show More
View Publication
Scopus Clarivate Crossref
Publication Date
Sun Aug 30 2015
Journal Name
Statistical Analysis Of The Relations Between Api,specific Gravity And Sulfur Content In The Universal Crude Oil
Statistical Analysis of the Relations between API, Specific Gravity and Sulfur Content in the Universal Crude Oil
...Show More Authors

Publication Date
Tue Jan 01 2019
Journal Name
Plant Archives
Assessment of organic carbon content in different topographic from northern Iraq using remote sensing technique and GIS
...Show More Authors

Scopus (4)
Scopus
Publication Date
Sat Oct 01 2022
Journal Name
Colloids And Surfaces A: Physicochemical And Engineering Aspects
Application of natural deep eutectic solvents in bulk liquid membrane system for removal of free glycerol from crude fatty acid methyl ester
...Show More Authors

Fatty Acid Methyl Ester (FAME) produced from biomass offers several advantages such as renewability and sustainability. The typical production process of FAME is accompanied by various impurities such as alcohol, soap, glycerol, and the spent catalyst. Therefore, the most challenging part of the FAME production is the purification process. In this work, a novel application of bulk liquid membrane (BLM) developed from conventional solvent extraction methods was investigated for the removal of glycerol from FAME. The extraction and stripping processes are combined into a single system, allowing for simultaneous solvent recovery whereby low-cost quaternary ammonium salt-glycerol-based deep eutectic solvent (DES) is used as the membrane phase.

... Show More
Scopus (13)
Crossref (14)
Scopus Clarivate Crossref
Publication Date
Mon Dec 31 2012
Journal Name
Al-khwarizmi Engineering Journal
Analysis of the Effects of Aggressive Shot Peening on Fatigue Life of 7075 – T6 Aluminum Alloy
...Show More Authors

 For many years controlled shot peening was considered as a surface treatment. It is now clear that the performance of control shot peening in terms of fatigue depends on the balance between its beneficial (compressive residual stress and work hardening) and beneficial effects (surface hardening).

The overall aim of this paper is to study the effects of aggressive shot peening on fatigue life of 7075 – T6 aluminum alloy. The fatigue life reduction factor (LRF) due to the aggressive shot peening was established and empirical relations were proposed to describe the behavior of LRF, roughness and fatigue life. The benefits of shot peering in terms of fatigue life are dependent on the shot peening time (SPT).

... Show More
View Publication Preview PDF
Publication Date
Fri Nov 01 2013
Journal Name
International Journal Of Advanced Research
The effects of alkaloid extracted of Solanum nigrum leaves on the biological performance of Dialerodus citri
...Show More Authors

Publication Date
Thu May 01 2014
Journal Name
European Journal Of Pharmacology
The effects of different doses of silibinin in combination with methotrexate on testicular tissue of mice
...Show More Authors

Methotrexate (MTX) is widely used chemotherapeutic agent with different side effects including germ cells toxicities. Silibinin is one of the structural isomers of silymarin, with different phytotherapeutic applications, and its possible protective effects against MTX induced germ cells damage were investigated in this work. Twenty five male mice were divided into five groups (n=5) allocated as follows: Group 1 received buffer for five days given by single intraperitoneal (IP) injection per day; Group 2 in addition to buffer for five days, animals received at day five single dose of 20mg/kg of MTX IP. Groups (3, 4, and 5) received respectively, (50, 100, or 150mg/kg body weight) of silibinin IP single daily dose for five days then at day fi

... Show More
View Publication
Scopus (28)
Crossref (29)
Scopus Crossref
Publication Date
Mon May 01 2023
Journal Name
Materials Today: Proceedings
An experimental study of the effects of matrix acidising on the petrophysical characteristics of carbonate formation
...Show More Authors

View Publication
Scopus (8)
Crossref (2)
Scopus Crossref
Publication Date
Sun Jan 01 2023
Journal Name
Food Science And Technology
Modelling of inactivation of microorganisms in the process of sterilization using high pressure supercritical fluids
...Show More Authors

View Publication
Scopus (2)
Crossref (1)
Scopus Crossref
Publication Date
Sun Feb 17 2019
Journal Name
Iraqi Journal Of Physics
Density distributions, form factors and reaction cross sections for exotic 11Be and 15C nuclei
...Show More Authors

The ground state proton, neutron and matter densities of exotic 11Be and 15C nuclei are studied by means of the TFSM and BCM. In TFSM, the calculations are based on using different model spaces for the core and the valence (halo) neutron. Besides single particle harmonic oscillator wave functions are employed with two different size parameters  Bc and Bv.  In BCM, the halo nucleus is considered as a composite projectile consisting of core and valence clusters bounded in a state of relative motion. The internal densities of the clusters are described by single particle Gaussian wave functions.

 Elastic electron scattering proton f

... Show More
View Publication Preview PDF
Crossref